Installing t-embed

[Robin69CH]

Good morning,

I purchased the T.embed ESP32-S3 and I am trying to install your system, but when I connect it, it tells me that this does not support your software (StickCPlus2).

I don't understand why this is so, since it is possible to install.

Can you please help me?

[bmorcelli]

Hello.. you must install the right device version... Each devoce has a different binary file, with a different setup (tft, pinouts etc...)

So, on the flasher choose: BetaRelease> Lilygo> T-Embed... And here you must pay attention for the T-Embed version you have.. if CC1101 or regular one.

To no install on StickCPlus2, you must choose M5Stack> StickCPlus2

The file for one device won't work on other device.

[mockme41]

Hey so I have the lilygo tembed cc1101 and im going through the process of installing thr bruce firmware on the flasher site and i follow every step of the install and when im done and disconnected from my pc I go to turn it on and i get a blank screen. So after several attempts I connect back to the bruce flasher site and check the logs and it is trying to boot a firmware over and over x100, idk what else to do plz help.

[Huzzla101]

If screen is blank , how do you know its turned on ? The wheel lights up ? I cant assure you this will work but try.... Re install Bruce default version not beta... Then after you have completed and flasher site says all is ok and success and you disconnect lily from pc.--- Then Dont turn it on with a button but open backside and at upper left side its a small black button named RST , click that once and check if bruce starts up then... Worth the try

…

On Sun, Jun 22, 2025 at 9:32 AM mockme41 ***@***.***> wrote: Hey so I have the lilygo tembed cc1101 and im going through the process of installing thr bruce firmware on the flasher site and i follow every step of the install and when im done and disconnected from my pc I go to turn it on and i get a blank screen. So after several attempts I connect back to the bruce flasher site and check the logs and it is trying to boot a firmware over and over x100, idk what else to do plz help. — Reply to this email directly, view it on GitHub <#1214 (reply in thread)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/BLDL6BUJ7N277ZSOSQNDAID3EZL2XAVCNFSM6AAAAAB5MBVP3OVHI2DSMVQWIX3LMV43URDJONRXK43TNFXW4Q3PNVWWK3TUHMYTGNJUGEZDEMA> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

-- Kind Regards C.R May Prosperity allways be with us!!