Control the tilt angle during operation

[clown991]

When I use it, I change the tilt angle of the wind turbine by directly changing the tilt value in the YAML file. However, when there are multiple wind turbines, either the angle is fixed, or each wind turbine has different customs that can be changed through the tilt table. I cannot specify each one independently.I saw this question raised in our previous discussion, but there was no response. In addition, can you provide an interface to know the current status of each wind turbine after each run? Thank you very much. Looking forward to your reply.
And when I was in AWC mode and changed the angle of the 3-tilt at the same time, I found that the power of the first wind turbine remained unchanged

[misi9170]

Hi @clown991 , I've responded to your question over on #653 .