Elevator Right D/R and Expo not working correctly

[GoogleCodeExporter]

What steps will reproduce the problem?
Adjusting the elevator's Right D/R and/or Right Expo moves the center point of 
the channel as viewed in the simulator. This does not happen on the left D/R 
and Expo.
I have no trim adjustment on the elevator.


What is the expected output? What do you see instead?
The channel center point (Or trim point) not to change.

What version of the product are you using?
eePskye Version 405

On what operating system?
Windows 7


Please provide any additional information below.
I am using AETR convention, So all of this is happening on channel 2.
I am only using the High rate.

Original issue reported on code.google.com by farmerto...@gmail.com on 13 Jul 2014 at 7:09

[GoogleCodeExporter]

Looking further into this, I found that this issue occurs if the Throttle Expo 
box is checked in the setup tab. 

Original comment by farmerto...@gmail.com on 14 Jul 2014 at 12:22

[GoogleCodeExporter]

I think this is related to changes in the way the stick mode is handled. In 
mode 2, there may be problems with ELE and THR being swapped.

Original comment by michael....@mypostoffice.co.uk on 31 Jul 2014 at 1:36