Kinetos Wallbox OPENEVSE configuration or port

[StefanRied]

Hello,
there was a wallbox vendor called Kinetos in Germany.
They did pretty nice boxes based on the ESP32.
Some of them are still on ebay.

Did anybody already made an configuration / instruction to run OpenEVSE on this board and hardware?

thanks for any hints.

Inside the V1 looks like this.

and the more integrated version 2 looks like this:

[pohlinkzei]

Hi, have you tried to flash any stock firmware? I bought one off ebay. I'll try to figure out how different the hw is, once its delivered.

[pohlinkzei]

I have got the wallbox and it is the AUEM-Version (your first picture) It appears to be based on openevse4. I was able to verify a couple of connections but the entire board is coated with something to make it not to malfunction from moisture so measurements are not that easy. The wifi module is a WT32-ETH0, so the openEVSE-Wifi should work, if one builds for WT32-ETH0.

First funny finding is: The ISP header has a wrong pin1-marking.

[pohlinkzei]

Here is the ESP32 config for the AUEM Wallbox: https://github.com/pohlinkzei/openevse_esp32_firmware/blob/kinetos-auem/platformio.ini#L454-L485

I also needed to comment out the init for littlefs:
https://github.com/pohlinkzei/openevse_esp32_firmware/blob/kinetos-auem/src/main.cpp#L121-L124