G96 ( Constant Surface Speed ) on Lathe mode is idle run #403
Replies: 3 comments 1 reply
-
Post the gcode you are running. And also the $I output from the controller. Here is a test file I am using - and it seems to work as it should: |
Beta Was this translation helpful? Give feedback.
-
[VER:1.1f.20231005:] here , i give u the gcode (facing.txt) |
Beta Was this translation helpful? Give feedback.
-
} its in spindle control.c , im commenting the delay_sec & on_delay and now its work perfectly fine without idle run , but did the delay really needed ? |
Beta Was this translation helpful? Give feedback.
-
0.TEST.HM.ngc.-.Universal.Gcode.Platform.Version.2.0.14.2023-12-12.08-53-25.mp4
hi guys , i just test a G96 on my lathe machine , but it seems that the Machine status is in idle run conditions when its actually run the gcode , can i have a clue what is happening , is it because it should be count the spindle rpm before it run again ? i try to figure it out but i have no clue , here is the video and the G96 ( CSS) code
Beta Was this translation helpful? Give feedback.
All reactions