Problem connecting to Tinymovr through CAN Bus using CANine firmware

[SpeakersOFF]

Hello,
I'm having a problem connecting to the tiny move. Someone help?

$ lsusb
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 008: ID 0483:c1b0 STMicroelectronics CANine CDC
Bus 001 Device 004: ID 0e0f:0008 VMware, Inc. Virtual Bluetooth Adapter
Bus 001 Device 003: ID 0e0f:0002 VMware, Inc. Virtual USB Hub
Bus 001 Device 002: ID 0e0f:0003 VMware, Inc. Virtual Mouse
Bus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
~$ sudo tinymovr_cli
Tinymovr Studio 1.6.2
Listening for nodes...

In [1]:

it does seem to find it.

[yconst]

Hi, have you tried setting the TERM DIP switch to on?

[SpeakersOFF]

I have tried both on and off, but it still doesn't work. I bought two more boards and two can controllers. I still have the same issue. Just for setup I have 24vdc wire to +,- and the can controller is connected to an can 1 on the motor controller

[yconst]

Is this a virtual machine?

[SpeakersOFF]

YES.

[yconst]

Could you provide an image of your setup, with clearly shown connections?

In addition, have you tried using slcan instead of the CANine firmware (just as a verification)?

I have never used the setup in a virtual machine. Even though it should not be an issue since it is discovering your interface, I'd try on a physical machine just for good measure.