-
|
I recently upgraded to an RS 8 P&S panel Rev T.2g. Everything is working fine but I notice is in the log file every few seconds: iAQ Touch: Not sure where to add Button 1 - LoadingPage = Status (diff ID) I've attached a log file, my config file, and the output of the serial logger. |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 2 replies
-
|
Sorry, I've edited the message. While debugging someone else's panel I noticed Rev Yg was using a different ID for status vs previous revision. Hence I put a note in the code. Thanks for posting this, as it's good to know they introduced it in T.2g, because in T.2 is still uses the old ID. So now I have harrowed the exact revision it changed. As for the "Not sure where to add Button 1", you can ignore that message. But I'll go over your logs and make sure. |
Beta Was this translation helpful? Give feedback.
-
|
Thanks! |
Beta Was this translation helpful? Give feedback.
-
|
In Aqmanager, under |
Beta Was this translation helpful? Give feedback.
Sorry, I've edited the message.
That's totally normal, is was a message I was using while testing. I forgot to remove it from the notice debug level, I'll do that in the next release.
While debugging someone else's panel I noticed Rev Yg was using a different ID for status vs previous revision. Hence I put a note in the code. Thanks for posting this, as it's good to know they introduced it in T.2g, because in T.2 is still uses the old ID. So now I have harrowed the exact revision it changed.
As for the "Not sure where to add Button 1", you can ignore that message. But I'll go over your logs and make sure.