B2500-d ADAPATIVE_MODE

[theopenconcept]

Question

My setup is one single B2500-d fw: 113.8 HMJ-2
hm2mqtt and astrameter
so far most things seem work ... but:

I set ADAPATIVE_MODE true.

When i set "CT connected Phase" to "none" after one cycle it changes to "unknown". Then for some time nothing seems to happen (about half a minute or so) then output very slowly aproaches the aggregated sum of Phase1-3 and when reaching it the output at once goes zero and "CT connected Phase" switches to "searching".

When i set "CT connected Phase" to any of Phase 1-3 output is constantly 40Watt whatever the value of the corresponding sensor is.

Is this some config issue/ am i missing s.th. or is it a bug?

Device Model (optional)

No response

Firmware Version (optional)

No response

hm2mqtt Configuration

hm2mqtt Logs

Hame Relay Configuration

Hame Relay Logs

[theopenconcept]

i just updated astrameter to your recent changes and at a first glance for some minutes it worked.
Then after lets say 2 or 3 minutes and regulating around zero for some cycles:

First i set Connected Phase from Phase n to "none" which then changes to "unknown" and regulation seems to begin.

CT Status changed from "Diagnosing CT001 channel" to "Diagnosis timeout" after mentioned time

And i also noticed a change in Depth of Discharge from "OK" to "Problem" no matter i set to 35%, 50% or 0
This indicator changes at the time of triggering by setting Connected Phase and it vanishes again when regulating stopped

[theopenconcept]

should i better put this to AstraMeter-Issues ?