Description

ESP8266 chip with working arduino to communicate with Jetson Nano Hub. (used with smarthome_v1 or smarthome_v2)

How this code SHOULD work.

Steps:

1: Start AutoConnect in order to configure start up variables * COMPLETE *

        (i.e. WiFi SSID | Pass  AND Database credentials.) 

2: Connect to MariaDB and get setup information * INCOMPLETE *

        (i.e. mosquitto broker ip, pin assignments, mosquitto channels, commands) 

3: Connect to Mosquitto Broker * COMPLETE *

4: Listen to appropriately formatted mosquitto channels * INCOMPLETE *

           i.e. channels are given as...
            1) home/rooms/room_name/things/thing_name/commands
            2) home/rooms/room_name/things/thing_name/info
            3) home/rooms/room_name/things/thing_name/interrupt

          Need to be formatted as (replace room_name and thing_name)
           i.e. channels are formatted correctly when...
            1) home/rooms/Kitchen/things/Kitchen_Thing1/commands
            2) home/rooms/Kitchen/things/Kitchen_Thing1/info
            3) home/rooms/Kitchen/things/Kitchen_Thing1/interrupt

5: Publish thing status when interrupts are triggered to channel 3 (interrupt) * INCOMPLETE *

          i.e. payload = "
                       "{
                         "sensor_name" :   ["motion1", "LDR1"],
                          "sensor_type" :   ["motion", "LDR"],
                          "sensor_value":   [1, 2423]
                         "}

6: Perform commands given from MariaDB (step 2) and sent to channel 1 (Step 2 - commands) * INCOMPLETE *

         i.e. payload = "read_status"
         i.e. payload = "relay_on"
         i.e. payload = "relay_off"