Duo-V1.0.6
Change log V1.0.6
- README: Add instructions for using Docker to compile images.
- Support mailbox communication between big core and small core, see here for details.
The firmware introduction:
- Enable ssh
- Enable RNDIS
- Blink LED
- Root password: milkv
Login via RNDIS using ssh:
If you want to disable LED blinking:
mv /mnt/system/blink.sh /mnt/system/blink.sh_backup && sync
then reboot the board.
Use the IO-Board
Note that when using the IO-Board, the USB network (RNDIS) is not available, Please use the Ethernet interface on the IO-Board.
If you need to assign a fixed MAC address to the Ethernet port of the IO-Board, please execute the following command(Replace the MAC address in the command with the MAC address you want to set, and please note that MAC addresses of different devices within the same network segment must not be duplicated).
echo "pre-up ifconfig eth0 hw ether 78:01:B3:FC:E8:55" >> /etc/network/interfaces && sync
then reboot the board.
Enable the 4 USB ports on the IO-Board:
rm /mnt/system/usb.sh
ln -s /mnt/system/usb-host.sh /mnt/system/usb.sh
sync
then reboot the board.
Restore the USB network (RNDIS) when the IO-Board is not used:
rm /mnt/system/usb.sh
ln -s /mnt/system/usb-rndis.sh /mnt/system/usb.sh
sync
then reboot the board.