WLED Remote Controller (Lilygo T4 S3)
My goal was to create a small, portable, touchscreen-based remote to send commands to my WLED controller.
Hardware Components for Remote Controller:
- Lilygo T4 S3
- EEMB Lithium Polymer Battery 3.7V 1100mAh (603449)
- Vertical Micro Slide Switch (SS-12D00, 3 Pin, 2 Pos)
- MagSafe Ring
For that I designed a complete 3D printable case.
The wireing is quite simple since the lilygo board already has a LiPo battery connector:
The remote runs on ESPHome and uses LVGL components.
The final GUI supports:
- relay control (page 1)
- color & brightness (page 2)
- effects control (page 3)
- settings control (longpress tab 1)
