Miscellaneous information about the Flashforge Adventurer 3 3D printer.

Gcode

General

The Flashforge Adventurer 3 uses a custom Flashforge flavor of Gcode. There is some information about it regarding getting slicers like Prusa Slicer and Cura working with the printer. The Cura slicer comes with a community profile for the Adventurer 3 based on the documentation from flashforge

• Prusa3D forum thread discussing getting Prusa Slicer to work with the FF A3, including a config bundle with custom profiles
  • config bundle direct link
• Reddit thread discussing the M118 command in the Gcode generated by FlashPrint
• Reddit thread discussing working modifications to Gcode from Prusa Slicer
• Reddit thread discussing the temperature commands
• Official Flashforge document describing how to set up Cura for the Adventurer 3

Flashforge Gcode flavor spesific commands

Command	Example command	Description	References / Links

Network protocol

The printer have a console listening at port 8899 accepting Gcode commands. The FlashPrint software uses this port to transfer gcode and start print, and to receive status during the print.